I added in a new column in Clay and now all my other columns keep having a circular error issue. How can i fix this?
If you’re seeing a circular error after adding a new column, it’s likely due to a loop in your column dependencies or integrations. Here’s how to fix it:
Delete the affected column that’s causing the error.
Create a fresh column with the same settings.
Re-map your data to the write-to-other-table (if used), making sure auto-dedup is enabled in the target table.
If you use “Write to another table,” double-check that all columns and tables exist and are correctly set up, and re-add the integrations if needed.
Is that what you were looking for?
so i have to delete and redo for all columns? that's alot of columns though
You don’t need to delete and redo all your columns to fix a circular error. Instead, try these steps:
Pause all automations in the affected table to stop the loop from running further [1].
Add a “processed” flag or status column to track which rows have already been processed, so enrichments only run on new or unprocessed data .
Review webhook and integration setups to ensure there’s no bidirectional sync between tables or with external systems [4].
Test with a small batch of rows first to confirm the fix works before applying it to all data .
This approach should resolve the circular error without needing to recreate your columns .
Did that answer your question?
so the whole table was ok before adding in that 1 new column. why now every column has circular errors?
Adding one new column can trigger circular errors if it creates a dependency loop—like if it updates a field that another column depends on, or if it’s part of a cross-table or webhook loop. This can cause all affected columns to get stuck in a loop, even if they worked fine before [1].
To fix it without deleting and redoing all columns:
Pause all automations in the table to stop the loop [2].
Check each column’s run conditions and dependencies. Make sure no column is triggering itself or another in a loop. Use “Only run if” conditions to prevent re-triggering, and avoid having an enrichment update the field that triggers it .
Add a “processed” flag or status column to track which rows have already been processed, so enrichments only run on new or unprocessed data .
Review webhook and integration setups to ensure there’s no bidirectional sync .
Test with a small batch of rows first to confirm the fix works before applying it to all data.
This approach should resolve the circular errors without needing to recreate your columns .
Was this helpful?
If you still need help resolving the circular errors in your table, I’m here to assist you further. Would you like to provide more details about your setup or the specific issues you’re encountering?
i had to delete the column and create a new one. this solved the issue. why is this so?
Deleting and recreating the column often fixes circular errors because it resets the column’s dependencies and automations, breaking any loops that were created when the column was first added. This is a common workaround when a column’s integration or run conditions get stuck in a loop, especially if it’s tied to “Write to another table” or other automations. Starting fresh with a new column clears out any corrupted or conflicting settings, allowing the workflow to run properly again .
Is that what you were looking for?
If you need any more help with the circular errors or anything else in your table, please let me know. Would you like to share more details about your current setup or any other issues you’re trying to resolve?
