Gabe C.

Can’t really see the full context but directionally that sounds correct! Edit: just setup a table like yours and tested it. Could probably be better with 1-2 more steps but if you're using an AI column, it should figure things out I suppose.

You could also just do a lookup on a sorted table and send 2 records to another table — much faster.

I've also noticed that when adding custom MCPs: 1) it’s hard to tell if it's failed to connect (it just shows a loader perpetually I’m sure this isn't an intended behavior but Clay probably didn't think to handle it differently in a more intuitive way?) 2) Is there anyway to test, from Claygent, if the MCPs were connected successfully and if it's able to use the tools correctly?

Luca P. thanks so much for this! That’s very helpful to know — wished this was in the docs 😂 it's a great answer

Kinda sketch that doesn’t really help 😭 could you put me in touch with a support engineer if possible 🙏?

If you see this. it’s not clear what

Yes I do need more help with custom MCPs in Claygent 😞

Casper S. that actually did the trick and it works now! Though it’ll be nice for Clay to add better error messages 😢

Casper S. ahh that's really helpful to know!!