Troubleshooting Errors in Job Posting Table Setup for Software Engineering

·Jun 23, 2025 09:00 PM·

I set up a table to find new job postings for software engineering roles. We had ChatGPT provide the list for the roles we would covered, added them in the right section for the action and then saved. But when we ran it I keep getting this error. Any ideas on what I could be doing wrong?

1 comment

· Sorted by Oldest

Channeled
APP
·
·
Without seeing the specific error message, here are the most common causes: Clear your browser cache and refresh - this resolves many persistent error messages. Check your source setup - when adding a source to an existing table, you must have the appropriate columns set up. For job searches, ensure you have the required input columns configured properly. Source changes don't auto-update - if you edited source filters after running the table, it won't retroactively update results. You need to delete and re-run the step or duplicate the table with updated source settings. To help troubleshoot further, please share the specific error message you're seeing.
Sources: Sources | Documentation | Clay University Sources | Documentation | Clay University

Channeled
APP
·
·
Without seeing the specific error message, here are the most common causes: Clear your browser cache and refresh - this resolves many persistent error messages. Check your source setup - when adding a source to an existing table, you must have the appropriate columns set up. For job searches, ensure you have the required input columns configured properly. Source changes don't auto-update - if you edited source filters after running the table, it won't retroactively update results. You need to delete and re-run the step or duplicate the table with updated source settings. To help troubleshoot further, please share the specific error message you're seeing.
Sources: Sources | Documentation | Clay University Sources | Documentation | Clay University