Troubleshooting Data Formatting in Clay for Company Addresses

·

hi support - I'm pulling company addresses with the datagma provider in clay right now. However, it's lumping the physical street, city, and country into one field while I want three distinct fields pulled from the provider (i.e. the information should show up in three separate columns, not one) - is there a way to troubleshoot this?

2 comments

· Sorted by Oldest

Channeled
APP
·
·
Based on the Datagma integration capabilities in Clay, you can actually pull these location fields separately. Instead of using a single address field, you can select the specific location components you need: • Company Location - Address (for street address)• Company Location - City• Company Location - CountryWhen setting up your Datagma enrichment, make sure to add each of these fields separately to your table columns. Each field will pull the corresponding location component into its own distinct column. Sources: Enrich Company with Datagma | Clay.com Datagma x Clay integration | Clay.com
Channeled
APP
·
·
Hi Sameera P.! This thread was recently closed by our Support team. If you have a moment, please share your feedback:

Channeled
APP
·
·
Based on the Datagma integration capabilities in Clay, you can actually pull these location fields separately. Instead of using a single address field, you can select the specific location components you need: • Company Location - Address (for street address)• Company Location - City• Company Location - CountryWhen setting up your Datagma enrichment, make sure to add each of these fields separately to your table columns. Each field will pull the corresponding location component into its own distinct column. Sources: Enrich Company with Datagma | Clay.com Datagma x Clay integration | Clay.com
Channeled
APP
·
·
Hi Sameera P.! This thread was recently closed by our Support team. If you have a moment, please share your feedback: