.png){kind=logo}
Output keeps going missing from claygent columns
Output keeps going missing from claygent columns
Output keeps going missing from claygent columns
If your Claygent column outputs are missing, the issue is likely related to output field configuration. Make sure you've properly defined column outputs in the Claygent pop-out modal for each data point you want to extract. To fix this: 1. Check that you've identified all data points needed in your prompt 2. Define specific column outputs for each piece of information 3. In your prompt, explicitly instruct Claygent which information should go to which column output Try running a test on a few rows first to verify your configuration works before applying to your full dataset.
I had run a lot of: research prospet Company research Personalized invite But on returning to the table, none of it is present
If your Claygent columns aren’t showing results, it’s probably due to how your outputs are set up. Double-check the configuration in the Claygent side panel to ensure each data point has a mapped column. To resolve it:
Make sure your prompt includes all the data you want extracted.
Assign each piece of info to a clear output column.
Clearly tell Claygent where each output should go.
Test on a small batch first to confirm everything is working before scaling.
the outputs were all there before
now they are missing from those columns
Here’s a clean and composed way to reply to that: Got it. If the outputs were showing earlier and are now missing, it’s likely a config reset or prompt change caused it. Quick things to check:
Reopen the Claygent modal and confirm the output columns are still mapped.
Make sure the latest version of your prompt still includes clear instructions for each output.
Try rerunning a few rows to see if the issue persists or was a temporary glitch.
Let me know what you see, happy to take a look.
Hey, sorry about that. Did you happen to update the table or change any dependencies? Usually, a column won’t run unless there’s been a change in the input or it’s been manually triggered. Let me know what you were expecting to happen, and I’ll help you troubleshoot from there.